Process Engineer

Process Engineer /Process Design Engineer Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.

Required Experience:

The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.

• Design Basis
• Licensor Technology Evaluation
• PFD and P&ID Preparation and or review for Urea Plant
• HMB
• Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
• PSV Relief load estimation, PSV sizig
• Flare sizing, KOD sizing
• Pump sizing
• Compressor Calculations, Anti surge design, settle out calculations etc
• Steam generation and sizing calculations
• Design of Separators, columns, Heat Exchangers, tanks
• Hydraulic calculations, PSV sizing, Control valve sizing calculations
• Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
• 3D Model Review
• vendor offer reviews
• Experience across conceptual design, FEED, and detailed engineering phases.
• Operation experience is not preferred.

Software/Technical Skills & Tools

• Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.
• Strong understanding of process design, sizing, and optimization techniques.
• Ability to critically review calculations and propose practical engineering solutions.
• Strong technical documentation and report-writing skills.
• Fluent in spoken and written English.

Education:

• B tech Chemical Engineering / MTech Chemical Engineering
• 75% Marks in engineering are mandatory

Job Profile

Key Responsibilities

• Perform process design review and verification across conceptual, FEED, and detailed engineering stages.
• Prepare and review process design basis, philosophies, and engineering calculations.
• Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).
• Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.
• Perform and review PSV relief load estimation and PSV sizing calculations.
• Review flare system calculations, knockout drum sizing, and associated hydraulics.
• Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.
• Review design of separators, columns, heat exchangers, tanks, and other process equipment.
• Perform hydraulic calculations and control valve sizing reviews.
• Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.
• Participate in 3D model reviews and vendor technical document reviews.
• Prepare and review technical reports, calculation notes, and design review comments.
• Ensure compliance with applicable international codes, standards, and project procedures.
• Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.

Location: Abu Dhabi, UAE